A Short Article on Elbow as Pipe Fitting Private individual

2 years ago - Services - Davangere - 235 views

-- ₹

Ad Details

Location: Davangere

Price: -- ₹

Steel pipe elbow (sometimes also referred to as bends) is a key part of a pressure piping system used to change the fluid flow direction. It is used to connect two pipes with the same or different nominal diameters, and to make the pipe and thus the fluid direction turn to a certain direction of 45 degrees or 90 degrees. This change in fluid flow direction adds pressure losses to the system due to impact, friction, and re-acceleration.

90° Elbow

The 90 degree elbows are used to connect tubes at a 90° angle. As the name suggests, the elbow is always a right-angle in shape. Such type of elbow is also known as "90 bends or 90 ells". This is a pipe fitting device that is bent in such a way to produce a 90° change in the direction of flow of the fluid/gas in the pipe. The elbow is used to change the direction in piping and is also sometimes called a "quarter bend".

A 90° elbow attaches readily to pipes of various materials like plastic, copper, cast iron, steel, lead, rubber, etc. In other words, the 90° elbows are used to provide a joint between two pipes at right angles to each other. They are used as railing ends or corners on a level installation.

45° Elbow

45 Degree Elbow is also known as “45 bends or 45 ells”. The 45° pipe elbow is used to connect tubes at a 45° pipe angle. As the name suggests, this is a pipe fitting device that is bent in such a way to produce a 45° change in the direction of flow of the fluid/gas in the pipe.

180 degree Long Radius Elbow

The 180 Degree Elbows are used for connecting pipes of different diameters and find wide applications in various chemicals, construction industries, paper, cement & shipbuilders.

Butt Weld fitting Tee

Tees straight and reducing

The primary purpose of a Tee is to make a 90° branch from the main run of pipe. Standard, there are 2 possibilities, on behalf of the equal tee and reducing tee. The equal tee (or straight tee) is used as the branch has the same diameter as the run-pipe. The reducing tee is used as the branch has a smaller diameter than the run-pipe.

Dimensions and Standards

Send a message